...................................................................................................................................................................................................................................

Procedure 3-3: Top mounting

Before you begin

This section can be skipped if a top infrastructure (e.g. cable tray) does not exist.

Needed parts

The following parts are needed for a top mounting fixture:

• M12 threaded rods (CC408854065)

• M12 flat washers (CC901291914)

• M12 nuts (CC901291906).

Mounting

Proceed as follows to perform a top mounting fixture:

...................................................................................................................................................................................................

Screw 4 threaded rods (CC408854065) into the holes of the rack top plate as shown in the

figure below.

Figure 3-6 Mounting holes (ETSI-2 rack)

Mounting holes

(M12x20)

...................................................................................................................................................................................................

Fasten the threaded rods to the cross aux-framing. To do this use M12 flat washers

(CC901291914) and M12 nuts (CC901291906) as shown in the figure below.

365-374-198R10.5.4

Issue 1 July 2009

Rack top plate

Alcatel-Lucent – Internal

Proprietary – Use pursuant to Company instruction

ETSI-2 installation

Procedure 3-3: Top mounting

3-13

Table of Contents