Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 293

Power, software, and circuit pack installation
...................................................................................................................................................................................................................................
Procedure 5-5: NE software installation
Overview
The software generic has to be copied from the WaveStar
WaveStar
WaveStar
Electronic components can be destroyed by electrostatic discharge.
Hold circuit packs and SFPs (Small Form Pluggables) only at the edges or on the
insertion and removal facilities. Always observe the ESD instructions (cf.
discharge" (p.
Before you begin
Prior to performing this task, you must have the following:
1. 120 MB of free hard-disk drive space on your WaveStar
2. WaveStar
with CompactFlash
3. A valid login on the WaveStar
application" (p.
4. Administrator privileges for the PC being used to install software.
5. The CD-ROM that contains the generic of the E software.
6. ESD wrist strap.
7. Small Phillips screwdriver.
8. Alcatel-Lucent-provided empty and pre-formatted CompactFlash
unit. The size is dependent on the type of CTL and the application. Please choose
from the following options:
• 512 MB for CTL/- (traditional applications)
• 512 MB for CTL/2 (traditional applications)
• 1 GB for CTL/3T (traditional and extended DCC applications)
• 1 GB for CTL/3S (O
• 512 MB for CTL/4T (traditional applications)
• 512 MB for CTL/4S (extended DCC applications).
...................................................................................................................................................................................................................................
365-374-198R10.5.4
Issue 1 July 2009
®
CIT PC and then to an empty and pre-formatted CompactFlash
®
CIT.
NOTICE
ESD hazard
1-21)).
®
CIT (computer) with CompactFlash
™
adapter.
5-18)).
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
™
®
CIT (see Procedure 5-4: "Starting the WaveStar
S and extended DCC applications).
Software and circuit pack installation
Procedure 5-5: NE software installation
®
CIT CD-ROM to the
™
"Electrostatic
®
CIT (computer).
adapter or PCMCIA slot equipped
™
card for each CTL
card via
®
CIT
5-19