Altera Cyclone V User Manual page 80

5–28
Figure 5–16
Figure 5–16. Local Management Interface
The LMI interface is synchronized to pld_clk and runs at frequencies up to 250 MHz.
The LMI address is the same as the Configuration Space address. The read and write
data are always 32 bits. The LMI interface provides the same access to Configuration
Space registers as Configuration TLP requests. Register bits have the same attributes,
(read only, read/write, and so on) for accesses from the LMI interface and from
Configuration TLP requests.
When a LMI write has a timing conflict with configuration TLP access, the
configuration TLP accesses have higher priority. LMI writes are held and executed
when configuration TLP accesses are no longer pending. An acknowledge signal is
sent back to the Application Layer when the execution is complete.
All LMI reads are also held and executed when no configuration TLP requests are
pending. The LMI interface supports two operations: local read and local write. The
timing for these operations complies with the Avalon-MM protocol described in the
Avalon Interface
contents of any Configuration Space register. LMI write operations are not
recommended for use during normal operation. The Configuration Space registers are
written by requests received from the PCI Express link and there may be unintended
consequences of conflicting updates from the link and the LMI interface. LMI Write
operations are provided for AER header logging, and debugging purposes only.
c
In Root Port mode, do not access the Configuration Space using TLPs and the LMI bus
simultaneously.
Table 5–16
Table 5–16. LMI Interface (Part 1 of 2)
Signal
lmi_dout
lmi_rden
lmi_wren
lmi_ack
Cyclone V Hard IP for PCI Express
illustrates the LMI interface.
32
lmi_dout
lmi_ack
lmi_rden
lmi_wren
lmi_addr 12
32
lmi_din
pld_clk
Specifications. LMI reads can be issued at any time to obtain the
describes the signals that comprise the LMI interface.
Width Dir
32 O
1 I
1 I
1 O
Hard IP for
PCI Express
LMI
Configuration Space
128 32-bit registers
(4 KBytes)
Description
Data outputs
Read enable input
Write enable input
Write execution done/read data valid
November 2011 Altera Corporation
Chapter 5: IP Core Interfaces
LMI Signals