Editing A Program; Processing A Program (Editor) - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece

6.10 Editing a program

Note
Block-by-block execution
The <SINGLE BLOCK> key is also active in the overstore mode. If several blocks are entered
in the overstore buffer, then these are executed block-by-block after each NC start
Deleting blocks
6.10 Editing a program
6.10.1

Processing a program (editor)

With the editor, you are able to render, supplement, or change part programs.
Note
Maximum block length
The maximum block length is 512 characters.
134
4. Press the <CYCLE START> key.
The blocks you have entered are stored. You can observe execution in
the "Overstore" window.
After the entered blocks have been executed, you can append blocks
again.
You cannot change the operating mode while you are in overstore mode.
5. Press the "Back" softkey.
The "Overstore" window closes.
6. Press the <CYCLE START> key again.
The program selected before overstoring continues to run.
Press the "Delete blocks" softkey to delete program blocks you have en‐
tered.
Operating Manual, 05/2017, A5E40869190
Grinding