Measuring in JOG
4.2 Workpiece measurement
Spigot selection display
After selecting "spigot", a selection display is shown containing the additional following
options:
• "Rectangular spigot"
• "1 circular spigot"
• "2 circular spigots"
• "3 circular spigots"
• "4 circular spigots"
Note
Feed override
Set the feedrate override to the same value as for calibration!
4.2.5.2
Rectangular pocket or 1 hole or 1 spigot
It can be measured by selecting the center on the workpiece as the reference point and by
setting as the ZO (translation) :
• A paraxial rectangular pocket or
• a hole or
• a paraxial rectangular spigot or
• a circular spigot
Measurement is performed in both axes of the working plane.
4-24
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles