D2D And Ddcs Transmit Data - ABB ACS880 Series Firmware Manual

No. Name/Value
60.77 INU-LSU link
control
1...15
60.78 INU-LSU comm
loss timeout
0...65535 ms
60.79 INU-LSU comm
loss function
No action
Warning
Fault
61
61 D2D and DDCS
transmit data
61.01 M/F data 1
selection
None
CW 16bit
SW 16bit
Act1 16bit
Act2 16bit
Follower CW
Used speed
reference
Torque reference
act 5
Description
(Only visible with a BCU control unit)
Defines the light intensity of the transmission LED of RDCO
module channel CH1. (This parameter is effective only when
parameter 60.71 INU-LSU communication port
RDCO CH 1. FDCO modules have a hardware transmitter
current selector.)
In general, use higher values with longer fiber optic cables.
The maximum setting is applicable to the maximum length of
the fiber optic link. See Specifications of the fiber optic
master/follower link (page 39).
Light intensity.
(Only visible with a BCU control unit)
Sets a timeout for communication with another converter
(such as the supply unit). If a communication break lasts
longer than the timeout, the action specified by parameter
60.79 INU-LSU comm loss function
Timeout for communication between converters.
(Only visible with a BCU control unit)
Selects how the inverter unit reacts to a communication break
between the inverter unit and the other converter.
No action taken.
The drive generates a warning
Drive trips on 7580 INU-LSU comm
Defines the data sent to the DDCS link.
See also parameter group
Preselects the data to be sent as word 1 onto the
master/follower link.
See also parameter 61.25 M/F data 1
Master/follower functionality
None.
Control Word (16 bits)
Status Word (16 bits)
Actual value ACT1 (16 bits)
Note: Using this setting to send a reference to the follower is
not recommended as the source signal is filtered. Use the
"reference" selections instead.
Actual value ACT2 (16 bits)
Note: Using this setting to send a reference to the follower is
not recommended as the source signal is filtered. Use the
"reference" selections instead.
A word consisting of bits 0...11 of
and the bits selected by parameters 06.45...06.48.
Note: Bit 3 of the follower control word is kept on as long as
the master is modulating, and when it switches to 0, the
follower coasts to a stop.
24.01 Used speed reference
26.75 Torque reference act 5
is set to
is taken.
(AF80 INU-LSU comm
loss.
60 DDCS communication.
value, and section
(page 33).
06.01 Main control word
(page 219).
(page 239).
Parameters 355
Def/FbEq16
10
100 ms
Fault
0
loss). 1
2
Follower CW
0
1
4
5
6
27
6145
6731