Default Control Connections For The Sequential Control Macro - ABB ACS880 Series Firmware Manual

108 Application macros


Default control connections for the Sequential control macro

Fault
XPOW External power input
1 +24VI
24 V DC, 2 A
2 GND
XAI Reference voltage and analog inputs
1 +VREF 10 V DC, R
2 -VREF -10 V DC, R
3 AGND Ground
4 AI1+ Speed reference
0(2)...10 V, R
5 AI1-
6 AI2+ By default, not in use.
0(4)...20 mA, R
7 AI2-
XAO Analog outputs
1 AO1 Motor speed rpm
0...20 mA, R
2 AGND
3 AO2 Motor current
0...20 mA, R
4 AGND
XD2D Drive-to-drive link
1 B
2 A Drive-to-drive link
3 BGND
XRO1, XRO2, XRO3 Relay outputs
1 NC
2 COM
3 NO
1 NC
2 COM
3 NO
1 NC
2 COM
3 NO
XD24 Digital interlock
1 DIIL Run enable
2 +24VD +24 V DC 200 mA
3 DICOM Digital input ground
4 +24VD +24 V DC 200 mA
5 DIOGND Digital input/output ground
XDIO Digital input/outputs
1 DIO1 Output:
2 DIO2 Output:
XDI Digital inputs
1 DI1 Stop (0) / Start (1)
2 DI2 Forward (0) / Reverse (1)
3 DI3 Acc/Dec time set 1 (0) / set 2 (1)
4 DI4
Constant speed selection (see page 107)
5 DI5
6 DI6
Safe torque off circuits must be closed for the drive to start. See
XSTO
Hardware manual of drive.
X12 Safety options connection
X13 Control panel connection
X205 Memory unit connection
1...10 kohm
L
1...10 kohm
L
> 200 kohm
in
> 100 ohm
in
< 500 ohm
L
< 500 ohm
L
Ready run
250 V AC / 30 V DC
2 A
Running
250 V AC / 30 V DC
2 A
Fault (-1)
250 V AC / 30 V DC
2 A
Ready run
Running