ABB ACS880 Series Firmware Manual page 377

No. Name/Value
91.10 Encoder parameter
refresh
Done
Refresh
91.11 Module 1 type
None
FEN-01
FEN-11
FEN-21
FEN-31
FSE-31
91.12 Module 1 location
Slot 1
Slot 2
Slot 3
4...254
91.13 Module 2 type
None
FEN-01
FEN-11
FEN-21
FEN-31
FSE-31
91.14 Module 2 location
Slot 1
Slot 2
Slot 3
4...254
91.21 Module 1 temp
sensor type
None
PTC
KTY-84
Description
Validates any changed encoder interface module parameters.
This is needed for any parameter changes in groups 90...93
to take effect.
After refreshing, the value reverts automatically to Done.
Notes:
• Permanent magnet motors only: The drive will perform a
fresh autophasing routine (see page 61) at next start if the
motor feedback encoder settings have been changed.
• The parameter cannot be changed while the drive is
running.
Refreshing done.
Refreshing.
Defines the type of the module used as interface module 1.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
FSE-31.
Specifies the slot (1...3) on the control unit of the drive into
which the interface module is installed. Alternatively, specifies
the node ID of the slot on an FEA-03 extension adapter.
Slot 1.
Slot 2.
Slot 3.
Node ID of the slot on the FEA-03 extension adapter.
Defines the type of the module used as interface module 2.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
FSE-31.
Specifies the slot (1...3) on the control unit of the drive into
which the interface module is installed. Alternatively, specifies
the node ID of the slot on an FEA-03 extension adapter.
Slot 1.
Slot 2.
Slot 3.
Node ID of the slot on the FEA-03 extension adapter.
Specifies the type of temperature sensor connected to
interface module 1.
None.
PTC. (The unit is ohms.)
KTY84. (The unit is selected by parameter
selection.)
Parameters 377
Def/FbEq16
Done
0
1
None
0
1
2
3
4
5
Slot 2
1
2
3
1 = 1
None
0
1
2
3
4
5
Slot 3
1
2
3
1 = 1
None
0
1
96.16 Unit 2