ABB ACS880 Series Firmware Manual page 354

354 Parameters
No. Name/Value
Torque
Speed
Frequency
60.63 DDCS controller
act2 type
Auto
Transparent
General
Torque
Speed
Frequency
60.64 Mailbox dataset
selection
Dataset 32/33
Dataset 24/25
60.65 DDCS controller
comm supervision
force
Bit Name
0 Ext 1
1 Ext 2
2 Local
3...15 Reserved
0000b...0111b
60.71 INU-LSU
communication port
Not in use
RDCO CH 1
Description
01.10 Motor torque is sent as actual value 1. The scaling is
defined by parameter 46.03 Torque
01.01 Motor speed used
is defined by parameter
01.06 Output frequency
is defined by parameter
Selects the type/source and scaling of actual value ACT2
transmitted to the external controller.
Type/source and scaling follow the type of reference 2
selected by parameter 60.61 DDCS controller ref2
the individual settings below for the sources and scalings.
Reserved.
Reserved.
01.10 Motor torque is sent as actual value 2. The scaling is
defined by parameter 46.03 Torque
01.01 Motor speed used
is defined by parameter
01.06 Output frequency
is defined by parameter
Selects the pair of data sets used by the mailbox service in
the drive/controller communication.
See section External controller interface
Data sets 32 and 33.
Data sets 24 and 25.
Activates DDCS controller communication monitoring
separately for each control location (see section
vs. external control on page 20).
The parameter is primarily intended for monitoring the
communication with the controller when it is connected to the
application program and not selected as a control source by
drive parameters.
Value
1 = Communication monitoring active when Ext 1 is being used.
1 = Communication monitoring active when Ext 2 is being used.
1 = Communication monitoring active when local control is being
used.
DDCS controller communication monitoring selection.
(Only visible with a BCU control unit)
Selects the DDCS channel used for connecting to another
converter (such as a supply unit).
See also section Control of a supply unit (LSU)
None (communication disabled).
Channel 1 on RDCO module (with BCU control unit only).
scaling.
is sent as actual value 1. The scaling
46.01 Speed scaling.
is sent as actual value 1. The scaling
46.02 Frequency scaling.
scaling.
is sent as actual value 2. The scaling
46.01 Speed scaling.
is sent as actual value 2. The scaling
46.02 Frequency scaling.
(page 40).
(page 42).
Def/FbEq16
3
4
5
Auto
0
type. See
1
2
3
4
5
Dataset
32/33
0
1
0000b
Local control
1 = 1
Not in use;
RDCO CH 1
(95.20 b11,
95.20 b15)
0
11