ABB ACS880 Series Firmware Manual page 317

No. Name/Value
46.07 Frequency ref zero
scaling
0.00 ... 1000.00 Hz
46.11 Filter time motor
speed
0...20000 ms
46.12 Filter time output
frequency
0...20000 ms
46.13 Filter time motor
torque
0...20000 ms
46.14 Filter time power
out
0...20000 ms
46.21 At speed hysteresis
0.00 ... 30000.00
rpm
Description
Defines a frequency corresponding to a zero reference
received from fieldbus (either the embedded fieldbus
interface, or interface FBA A or FBA B). For example, with a
setting of 30, the fieldbus reference range of 0...20000 would
correspond to a speed of 30...[46.02] Hz.
Note: This parameter is effective only with the ABB Drives
communication profile.
Frequency corresponding to minimum fieldbus reference.
Defines a filter time for signals
01.02 Motor speed estimated,
and 01.05 Encoder 2 speed
Motor speed signal filter time.
Defines a filter time for signal
Output frequency signal filter time.
Defines a filter time for signal
Motor torque signal filter time.
Defines a filter time for signal
Output power signal filter time.
Defines the "at setpoint" limits for speed control of the drive.
When the absolute difference between reference
Speed reference act 7) and actual speed
for control) is smaller than
drive is considered to be "at setpoint". This is indicated by bit
8 of 06.11 Main status word.
Drive at setpoint
(06.11 bit 8 = 1)
Limit for "at setpoint" indication in speed control.
01.01 Motor speed
01.04 Encoder 1 speed filtered
filtered.
01.06 Output frequency.
01.10 Motor torque.
01.14 Output power.
(22.87
(90.01 Motor speed
46.21 At speed hysteresis, the
90.01 (rpm)
22.87 + 46.21 (rpm)
22.87 (rpm)
22.87 - 46.21 (rpm)
0 rpm
Parameters 317
Def/FbEq16
0.00 Hz
10 = 1 Hz
used, 500 ms
1 = 1 ms
500 ms
1 = 1 ms
100 ms
1 = 1 ms
100 ms
1 = 1 ms
100.00 rpm
See par.
46.01