ABB ACS880 Series Firmware Manual page 356

356 Parameters
No. Name/Value
Torque reference
used
ACS800 System
ctrl SW
Other
61.02 M/F data 2
selection
61.03 M/F data 3
selection
61.25 M/F data 1 value
0...65535
61.26 M/F data 2 value
0...65535
61.27 M/F data 3 value
0...65535
61.45 Data set 2 data 1
selection
None
CW 16bit
SW 16bit
Act1 16bit
Act2 16bit
Other
Description
26.02 Torque reference used
A follower status word compatible with an ACS800 (System
Control Program) master. With this setting, status word bit 0 is
cleared whenever the run enable signal is missing.
Source selection (see Terms and abbreviations
Preselects the data to be sent as word 2 onto the
master/follower link.
See also parameter 61.26 M/F data 2
For the selections, see parameter
Preselects the data to be sent as word 3 onto the
master/follower link.
See also parameter 61.27 M/F data 3
For the selections, see parameter
Displays the data to be sent onto the master/follower link as
word 1 as an integer.
If no data has been preselected by
selection, the value to be sent can be written directly into this
parameter.
Data to be sent as word 1 in master/follower communication.
Displays the data to be sent onto the master/follower link as
word 2 as an integer.
If no data has been preselected by
selection, the value to be sent can be written directly into this
parameter.
Data to be sent as word 2 in master/follower communication.
Displays the data to be sent onto the master/follower link as
word 3 as an integer.
If no data has been preselected by
selection, the value to be sent can be written directly into this
parameter.
Data to be sent as word 3 in master/follower communication.
Parameters 61.45...61.50
sets 2 and 4 to the external controller. These data sets are
used in ModuleBus communication with a "standard drive"
(60.50 DDCS controller drive type
Parameters 61.95...61.100
external controller. If no data has been preselected, the value
to be sent can be written directly into these parameters.
For example, this parameter preselects the data for word 1 of
data set 2. Parameter 61.95 Data set 2 data 1 value
the selected data in integer format. If no data is preselected,
the value to be sent can be written directly into parameter
61.95.
None.
Control Word (16 bits)
Status Word (16 bits)
Actual value ACT1 (16 bits)
Actual value ACT2 (16 bits)
Source selection (see Terms and abbreviations
(page 233).
on page 112). -
value.
61.01 M/F data 1
value.
61.01 M/F data 1
61.01 M/F data 1
61.02 M/F data 2
61.03 M/F data 3
preselect data to be sent in data
= ABB standard
display the data to be sent to the
on page 112). -
Def/FbEq16
6658
28
Used speed
reference
selection.
Torque
reference act
5
selection.
0
0
0
None
drive).
displays
0
1
4
5
6