ABB ACS880 Series Firmware Manual page 287

No. Name/Value
Output frequency
Motor current
Motor torque
DC voltage
Power inu out
Speed ref ramp in
Speed ref ramped
Speed ref used
Torq ref used
Freq ref used
Process PID out
Process PID fbk
Process PID act
Process PID dev
Other
36.02 PVL filter time
0.00 ... 120.00 s
36.06 AL2 signal source
36.07 AL2 signal scaling
0.00 ... 32767.00
36.09 Reset loggers
Done
All
PVL
AL2
36.10 PVL peak value
-32768.00 ...
32767.00
36.11 PVL peak date
-
36.12 PVL peak time
-
Description
01.06 Output frequency
01.07 Motor current (page 115).
01.10 Motor torque (page 115).
01.11 DC voltage (page 115).
01.14 Output power (page 116).
23.01 Speed ref ramp input
23.02 Speed ref ramp output
24.01 Used speed reference
26.02 Torque reference used
28.02 Frequency ref ramp output
40.01 Process PID output actual
40.02 Process PID feedback actual
40.03 Process PID setpoint actual
40.04 Process PID deviation actual
Source selection (see Terms and abbreviations
Defines a filtering time for the peak value logger. See
parameter 36.01 PVL signal
Peak value logger filtering time.
Selects the signal to be monitored by amplitude logger 2. The
signal is sampled at 200 ms intervals.
The results are displayed by parameters 36.40...36.49. Each
parameter represents an amplitude range, and shows what
portion of the samples fall within that range.
The signal value corresponding to 100% is defined by
parameter 36.07 AL2 signal
Amplitude logger 2 can be reset using parameter
loggers. The date and time of the last reset are stored into
parameters 36.50 and 36.51
For the selections, see parameter
Defines the signal value that corresponds to 100% amplitude. 100.00
Signal value corresponding to 100%.
Resets the peak value logger and/or amplitude logger 2.
(Amplitude logger 1 cannot be reset.)
Reset completed or not requested (normal operation).
Reset both the peak value logger and amplitude logger 2.
Reset the peak value logger.
Reset amplitude logger 2.
Displays the peak value recorded by the peak value logger.
Peak value.
Displays the date on which the peak value was recorded.
Peak occurrence date.
Displays the time at which the peak value was recorded.
Peak occurrence time.
(page 115).
(page 213).
(page 213).
(page 219).
(page 233).
(page 239).
(page 293).
(page 293).
(page 293).
(page 293).
on page 112). -
source.
scaling.
respectively.
36.01 PVL signal
Parameters 287
Def/FbEq16
3
4
6
7
8
10
11
12
13
14
16
17
18
19
2.00 s
100 = 1 s
Motor torque
36.09 Reset
source.
1 = 1
Done
0
1
2
3
0.00
1 = 1
-
-
-
-