ABB ACS880 Series Firmware Manual page 395

No. Name/Value
Factory
Hand/Auto
PID-CTRL
T-CTRL
Sequence control
FIELDBUS
96.05 Macro active
Factory
Hand/Auto
PID-CTRL
T-CTRL
Sequence control
FIELDBUS
96.06 Parameter restore
Done
Restore defaults
Clear all
Description
Factory macro (see page 96).
Hand/Auto macro (see page 98).
PID control macro (see page 100).
Torque control macro (see page 104).
Sequential control macro (see page 106).
Reserved.
Shows which application macro is currently selected. See
chapter Application macros
To change the macro, use parameter
Factory macro (see page 96).
Hand/Auto macro (see page 98).
PID control macro (see page 100).
Torque control macro (see page 104).
Sequential control macro (see page 106).
Fieldbus control macro (see page 109).
Restores the original settings of the control program, ie.
parameter default values.
Note: This parameter cannot be changed while the drive is
running.
Restoring is completed.
All editable parameter values are restored to default values,
except
• motor data and ID run results
• parameter 31.42 Overcurrent fault limit
• control panel/PC communication settings
• I/O extension module settings
• fieldbus adapter settings
• encoder configuration data
• application macro selection and the parameter defaults
implemented by it
• parameter 95.01 Supply voltage
• parameter 95.09 Fuse switch control
• differentiated defaults implemented by parameters
HW options word 1 and
• user lock configuration parameters 96.100...96.102.
All editable parameter values are restored to default values,
except
• control panel/PC communication settings
• fieldbus adapter settings
• application macro selection and the parameter defaults
implemented by it
• parameter 95.01 Supply voltage
• parameter 95.09 Fuse switch control
• differentiated defaults implemented by parameters
HW options word 1 and
• user lock configuration parameters 96.100...96.102.
PC tool communication is interrupted during the restoring.
(page 95) for more information.
96.04 Macro
95.21 HW options word 2
95.21 HW options word 2
Parameters 395
Def/FbEq16
1
2
3
4
5
6
Factory
select.
1
2
3
4
5
6
Done
0
8
95.20
62
95.20