ABB ACS880 Series Firmware Manual page 520

520 Fieldbus control through the embedded fieldbus interface (EFB)
Bit Name
8 JOGGING_1
9 JOGGING_2
10 REMOTE_
CMD
11 EXT_CTRL_
LOC
12...15 Reserved
Value STATE/Description
1 Accelerate to jogging 1 reference.
Notes:
• Bits 4...6 must be 0.
• See also section
0 Jogging 1 disabled.
1 Accelerate to jogging 2 reference.
See notes at bit 8.
0 Jogging 2 disabled.
1 Fieldbus control enabled.
0 Control Word <> 0 or Reference <> 0: Retain last Control
Word and Reference.
Control Word = 0 and Reference = 0: Fieldbus control
enabled. Reference and deceleration/acceleration ramp
are locked.
1 Select External Control Location EXT2. Effective if the
control location is parameterized to be selected from the
fieldbus.
0 Select External Control Location EXT1. Effective if the
control location is parameterized to be selected from the
fieldbus.
Jogging (page 57).