ABB ACS880 Series Firmware Manual page 369

No. Name/Value
90.12 Encoder 1 multiturn
revolutions
0...16777215
90.13 Encoder 1
revolution extension
-2147483648 ...
2147483647
90.14 Encoder 1 position
raw
0...16777215
90.15 Encoder 1
revolutions raw
0...16777215
90.20 Encoder 2 speed
-32768.00 ...
32767.00 rpm
90.21 Encoder 2 position
0.00000000 ...
1.00000000 rev
90.22 Encoder 2 multiturn
revolutions
0...16777215
90.23 Encoder 2
revolution extension
-2147483648 ...
2147483647
Description
Displays the revolutions of (multiturn) encoder 1 within its
value range (see parameter
This parameter is read-only.
Encoder 1 revolutions.
Displays the revolution count extension for encoder 1.
With a single-turn encoder, the counter is incremented when
encoder position (parameter 90.11) wraps around in the
positive direction, and decremented in the negative direction.
With a multiturn encoder, the counter is incremented when
the revolutions count (parameter 90.12) exceeds the value
range in the positive direction, and decremented in the
negative direction.
This parameter is read-only.
Encoder 1 revolution count extension.
Displays the raw measurement data of encoder 1 position
(within one revolution) as a 24-bit unsigned integer received
from the encoder interface.
This parameter is read-only.
Raw encoder 1 position within one revolution.
Displays the revolutions of (multiturn) encoder 1 within its
value range (see parameter
raw measurement.
This parameter is read-only.
Raw encoder 1 revolution count.
Displays encoder 2 speed in rpm.
This parameter is read-only.
Encoder 2 speed.
Displays the actual position of encoder 2 within one
revolution.
This parameter is read-only.
Encoder 2 position within one revolution.
Displays the revolutions of (multiturn) encoder 2 within its
value range (see parameter
This parameter is read-only.
Encoder 2 revolutions.
Displays the revolution count extension for encoder 2.
With a single-turn encoder, the counter is incremented when
encoder position (parameter 90.21) wraps around in the
positive direction, and decremented in the negative direction.
With a multiturn encoder, the counter is incremented when
the revolutions count (parameter 90.22) exceeds the value
range in the positive direction, and decremented in the
negative direction.
This parameter is read-only.
Encoder 2 revolution count extension.
92.14 Revolution data width).
92.14 Revolution data width) as a
93.14 Revolution data width).
Parameters 369
Def/FbEq16
-
-
-
-
-
-
-
-
-
See par.
46.01
-
-
-
-
-
-