ABB ACS880 Series Firmware Manual page 344

344 Parameters
No. Name/Value
Slot 3A
Slot 1B
Slot 2B
Slot 3B
RDCO CH 2
XD2D
60.02 M/F node address
1...254
60.03 M/F mode
Not in use
DDCS master
DDCS follower
D2D master
D2D follower
DDCS forcing
D2D forcing
60.05 M/F HW connection
Ring
Star
Description
Channel A on FDCO module in slot 3 (with ZCU control unit
only).
Channel B on FDCO module in slot 1 (with ZCU control unit
only).
Channel B on FDCO module in slot 2 (with ZCU control unit
only).
Channel B on FDCO module in slot 3 (with ZCU control unit
only).
Channel 2 on RDCO module (with BCU control unit only).
Connector XD2D.
Selects the node address of the drive for master/follower
communication. No two nodes on-line may have the same
address.
Note: The allowable addresses for the master are 0 and 1.
The allowable addresses for followers are 2...60.
Node address.
Defines the role of the drive on the master/follower link.
Master/follower functionality not active.
The drive is the master on the master/follower (DDCS) link.
The drive is a follower on the master/follower (DDCS) link.
The drive is the master on the drive-to-drive (D2D) link.
Note: Use the setting DDCS master
master/follower functionality (see page 33) through the XD2D
connector.
The drive is a follower on the drive-to-drive (D2D) link.
Note: Use the setting DDCS follower
master/follower functionality (see page 33) through the XD2D
connector.
The role of the drive on the master/follower (DDCS) link is
defined by parameters 60.15 Force master
follower.
The role of the drive on the drive-to-drive (D2D) link is defined
by parameters 60.15 Force master
Note: Use the setting DDCS forcing
master/follower functionality (see page 33) through the XD2D
connector.
Selects the topology of the master/follower link.
Note: Use the setting Star
functionality (see page 33) through the XD2D connector (as
opposed to a fiber optic link).
The devices are connected in a ring topology. Forwarding of
messages is enabled.
The devices are connected in a star topology (for example,
through a branching unit). Forwarding of messages is
disabled.
if using the
if using the
and 60.16 Force
and 60.16 Force
if using the
if using the master/follower
Def/FbEq16
3
4
5
6
12
7
1
Not in use
0
1
2
3
4
5
6
follower.
Ring
0
1