ABB ACS880 Series Firmware Manual page 396

396 Parameters
No. Name/Value
96.07 Parameter save
manually
Done
Save
96.08 Control board boot
0...1
96.09 FSO reboot
False
True
Other [bit]
96.10 User set status
n/a
Loading
Saving
Faulted
User set 1
User set 2
User set 3
User set 4
96.11 User set save/load
No action
User set I/O mode
Description
Saves the valid parameter values to permanent memory. This
parameter should be used to store values sent from a
fieldbus, or when using an external power supply to the
control board as the supply might have a very short hold-up
time when powered off.
Note: A new parameter value is saved automatically when
changed from the PC tool or control panel but not when
altered through a fieldbus adapter connection.
Save completed.
Save in progress.
Changing the value of this parameter to 1 reboots the control
unit (without requiring a power off/on cycle of the complete
drive module).
The value reverts to 0 automatically.
1 = Reboot the control unit.
Changing the value of (or the source selected by) this
parameter from 0 to 1 reboots the optional FSO-xx safety
functions module.
Note: The value does not revert to 0 automatically.
0.
1.
Source selection (see Terms and abbreviations
Shows the status of the user parameter sets.
This parameter is read-only.
See also section User parameter sets
No user parameter sets have been saved.
A user set is being loaded.
A user set is being saved.
Invalid or empty parameter set.
User set 1 has been loaded.
User set 2 has been loaded.
User set 3 has been loaded.
User set 4 has been loaded.
Enables the saving and restoring of up to four custom sets of
parameter settings. See section
90).
The set that was in use before powering down the drive is in
use after the next power-up.
Notes:
• Hardware configuration settings such as I/O extension
module, fieldbus and encoder configuration parameters
(groups 14...16, 47, 51...56, 58 and 92...93), and forced
input/output values (such as
included in user parameter sets.
• Parameter changes made after loading a set are not
automatically stored – they must be saved using this
parameter.
Load or save operation complete; normal operation.
Load user parameter set using parameters
mode in1 and 96.13 User set I/O mode
on page 112). -
(page 90).
User parameter sets (page
10.03 and 10.04) are not
96.12 User set I/O
in2.
Def/FbEq16
Done
0
1
0
1 = 1
False
0
1
-
0
1
2
3
4
5
6
7
No action
0
1