Subaru Impreza 2003 Service Manual page 3182

EXTERIOR/INTERIOR TRIM
13) Remove the six clips, and then remove the
bumper side cover.
14) Remove the upper bracket from body.
15) Remove the lower bracket (center) from body.
16) Loosen the three bolts, and then remove the
lower bracket (side).
NOTE:
On the right side, after removing the canister, loos-
en the bolts and remove the lower bracket.
REAR BUMPER
2. SEDAN MODEL
Refer to description about removal of rear bumper
of wagon model. <Ref. to EI-29, WAGON MODEL,
REMOVAL, Rear Bumper.>
B: INSTALLATION
1. WAGON MODEL
1) Install in the reverse order of removal.
Tightening torque:
Refer to COMPONENT in General Descrip-
tion.
EI-00532
<Ref. to EI-5, REAR BUMPER.>
2. SEDAN MODEL
1) Install in the reverse order of removal.
Tightening torque:
Refer to COMPONENT in General Descrip-
tion.
<Ref. to EI-5, REAR BUMPER.>
C: REPAIR
Refer to description about repair of front bumper.
<Ref. to EI-22, REMOVAL, Front Bumper.>
EI-00473
EI-00474
EI-00475
EI-30