10.Rear Spoiler
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Open the trunk lid.
3) Remove the electrical connector (A) of high
mount stop light.
4) Loosen the mounting nut of rear spoiler to re-
move rear spoiler.
CAUTION:
• When removing the nut, do not drop it into
trunk lid.
• Pay attention to avoid damage during remov-
al or installation.
Small-sized rear spoiler:
Four tightening positions
Large-sized rear spoiler:
Twelve tightening positions
B: INSTALLATION
1) Install in the reverse order of removal.
2) Clean the mounting surfaces of trunk lid and
spoiler before installation.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.46 ft-lb)
REAR SPOILER
(A)
EI-00453
(A)
EI-00520
EI-35
EXTERIOR/INTERIOR TRIM