Subaru Impreza 2003 Service Manual page 3150

SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
5. Sunroof Motor
A: REMOVAL
CAUTION:
• When removing the clip, use great care to not
damage the roof trim.
• Never rotate the sunroof motor after remov-
ing it.
1) Completely close the sunroof.
2) Disconnect the ground cable from battery.
3) Remove the sunroof lid. <Ref. to SR-5, REMOV-
AL, Sunroof Lid.>
4) Confirm the alignment mark (A) of sunroof
bracket link and the guide from sunroof opening. (If
the mark does not align, adjust to align the mark.)
5) Remove the roof trim. <Ref. to EI-50, REMOV-
AL, Roof Trim.>
6) Remove the motor cover.
7) Disconnect the harness connector and remove
the sunroof motor mounting screw.
SUNROOF MOTOR
B: INSTALLATION
CAUTION:
• Be careful not to move the sunroof cable
when installing sunroof motor.
1) Check the alignment mark (A) of sunroof motor.
(A)
2) Confirm the alignment mark (A) of sunroof
bracket link.
SR-00069
3) Install the sunroof motor.
4) After installing the motor, reconfirm the align-
ment marks of motor side and sunroof bracket link
side.
5) Connect the sunroof motor harness connector
and then connect the battery ground cable.
6) Check the sunroof operation with the procedure
as shown in the table.
SR-00062
(1) Completely close sunroof.
(2) Tilt-up sunroof to most upper position.
(3) Lower sunroof completely.
(4) Open sunroof to near the completely
open position.
(5) Completely open sunroof.
(6) Close sunroof 150 mm (5.91 in) away
from completely closed position.
(7) Completely close sunroof.
7) Install the sunroof lid and trims in the reverse or-
der of removal.
SR-8
(A)
Checking order
SR-00070
(A)
SR-00069
Switch position
Closed
Tilt-up
Tilt-down
Open
Open
Closed
Closed