Subaru Impreza 2003 Service Manual page 3135

18.Ignition Key Lock
A: REPLACEMENT
1) Remove the ground cable from battery.
2) Remove the steering column. <Ref. to PS-26,
REMOVAL, Tilt Steering Column.>
3) Secure the steering column in a vise. Remove
the bolt with a drill.
4) Remove the ignition key lock.
5) Use a new torn bolt. Tighten the torn bolt to end
of thread.
B: INSPECTION
1) Remove the instrument panel lower cover.
2) Remove the lower column cover.
3) Unfasten the hold-down clip which secures har-
ness and disconnect the connector of ignition
switch from body harness.
4) Turn the ignition key plate to each position and
check the continuity between terminals of ignition
connector.
Switch position Terminal No.
LOCK
ACC No. 1 and No. 2
No. 1 and No. 2
ON No. 1 and No. 4
No. 2 and No. 4
No. 1 and No. 3
ST No. 1 and No. 4
No. 3 and No. 4
If NG, replace the ignition switch.
IGNITION KEY LOCK
SL-00024
SL-00025
Standard
— —
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
SL-37
SECURITY AND LOCKS