GMC T Series 1994 Repair Manual page 901

Figure 13— Installing the Input Shaft Pilot Bearing
Tighten
£
• Extension housing bolts (25) to 42 N-m
(30 lbs. ft.).
5. Speed sensor (7) and speed sensor bolt (6) into
the extension housing (8).
^ Tighten
Figure 15— Installing the Front Output Shaft Front
Bearing
11. Front Cover
34. Output Shaft Bearing
Snap Ring
35. Output Shaft Bearing
Figure 16— Installing the Front Output Shaft Front
Bearing Snap Ring
10
10. Rear Case Half
39. Output Shaft Rear Bearing
Figure 17— Installing the Front Output Shaft Rear
Bearing
6. Output shaft oil seal (36) to the extension housing
(8) using J 37668. Align the water drain hole in the
output shaft oil seal (36) with the drain groove in
the extension housing (figures 19 and 20).
F7606
F7607