BEARINGS AND SEALS
Remove or Disconnect (Figures 9, 10, and 11)
Tools Required:
J 22912-01 Bearing Remover
J 23907 Puller
J 2619-01 Slide Hammer
J 29369-1 Front Output Shaft Front Bearing
Remover
J 38427 Front Output Shaft Rear Bearing Remover
1. Front output shaft oil seal (31) from the front cover
11
(
).
2. Input shaft oil seal (32) from the front cover (11).
3. Output shaft bearing snap ring (34) from the front
cover (11).
4. Output shaft bearing (35) from the front cover (11)
using J 2619-01 and J 29369-1 (figure 11).
5. Output shaft oil seal (36) from the extension hous
ing (8).
6. Using J 22912-01, press the sun gear shaft bearing
(33) from the sun gear shaft (18).
• Remove the drive sprocket spacer (16), drive
sprocket (17), and the viscous clutch (20) from
the sun gear shaft (18).
7. Input shaft pilot bearing (38) from the output shaft
assembly (24) using J 23907 (figure 9).
8. Output shaft rear bearing (39) from the rear case
half (10) using J 23907 and J 38427 (figure 10).
Bearing
J 29369-1
11. COVER, FRONT
34. SNAP-RING, FRONT OUTPUT SHAFT BEARING
35. BEARING, FRONT OUTPUT SHAFT
J 2619-01
V2829