Figure 29 Rear Band and Selective Thrust Washer
|jg | Clean
•
All Components.
| F | Inspect
1. Main shaft (662) for:
•
Damaged splines.
•
Wear.
Rear internal gear (666) for:
•
Stripped splines.
•
Damaged teeth.
•
Wear.
Output shaft (671) for:
•
Stripped splines.
•
Damaged teeth.
•
Cracks.
• Damaged bushing.
Output carrier assembly (661) for:
•
Wear.
•
Damaged lugs.
•
Pinion gear damage.
•
Washer wear.
•
Pinion gear and pocket thrust surfaces
damage.
Inspect
•
Excess pinion washer wear (end play should
be 0.228 to 0.610 mm (0.009 to 0.024 inch)
using feeler gage.
Front internal gear ring (658) for:
•
Damage.
•
Cracks.
Thrust washers (659, 673, and 674), bearings
(647 and 664) and races (646, 648, 663, 665,
and 669) for:
•
Damage.
Ring output speed sensor (660) for:
•
Tightness.
•
Damage.