Figure 29 Leak Check - 3rd Accum ulator
Figure 30 Third Accum ulator Retainer and Ball Asm. -
Installation
Lo and Reverse Clutch Piston
Figures 31 and 32
Tools Required:
J 34627 Snap Ring Remover/Installer
J 23327 Clutch Spring Compressor
| y |
Inspect
Figure 31
•
Lo and reverse piston (695) for:
-
Porosity or damage.
-
Ring groove damage.
•
Piston seals (696) for nicks or cuts.
•
Spring assembly (694) for damage.
•
Retainer ring (693) overstressed.
p 7 | Install or Connect
F ig u re 3 2
1. Piston seals (696) onto the piston (695).
•
Lubricate w ith Transjel™ J 36850 or
equivalent.
2. Piston (695) into the case.
•
Index the piston with the notch in the
bottom of the case.
3. Spring assembly (694) onto the piston.
•
Flat side of the retainer upward.
4. J 23327 over the spring assembly.
•
Compress the spring assembly past the ring
groove in the case hub.
5. Retainer ring (693) into the case hub ring groove
with J 34627.
8 CASE, TR ANSM ISSIO N
693 RING, LO A N D REVERSE CLUTCH RETAINER
694 SPRING ASSEMBLY, LO AND REVERSE CLUTCH
695 PISTON, LO A N D REVERSE CLUTCH
696 SEAL, TR A N SM ISSIO N (LO A ND REVERSE CLUTCH -
OUTER, CENTER, INNER)
693
RH0129-4L60-E