GMC T Series 1994 Repair Manual page 781

46. IDLER ASSEMBLY, REVERSE
53. COUNTERSHAFT ASSEMBLY, (MG5)
100. FORK, FIFTH AND REVERSE SHIFT
101. FORK, FIRST AND SECOND
203. BEARING, COUNTERSHAFT
301. HOUSING, REAR (4WD)
8. First speed gear needle bearing assembly (17).
9. Fifth speed gear (31) (figure 19).
10. Fifth speed gear bearing (30).
11. Snap ring (29) (figure 21).
12. Reverse speed gear assembly (25) and fifth-re­
verse synchronizer assembly (26) using J 36513
and hydraulic press (figure 20).
3707r5190
J 36515-15
J 36515
4. S H A F T A S S E M B L Y , MAIN (2WD)
5. S H A F T A S S E M B L Y , MAI N (4WD)
33. B E A R I N G A S S E M B L Y , O U T P U T S H A F T
43. RING, S N A P
44. RING, S N A P
45. R O T O R , S P E E D S E N S O R
46. IDLER A S S E M B L Y , R E V E R S E
53. C O U N T E R S H A F T A S S E M B L Y , (MG5)
100. FORK, FIFTH A N D R E V E R S E SHIFT
101. FORK, FIRST A N D S E C O N D SHIFT
102. FORK, THIRD A N D F O U R T H SHIFT
Figure 14— Gears and Shift Forks
B. Leave the s y n c h ro n iz e r rin g s (2) on the
first-second synchronizer assembly (19) to pre­
vent the synchronizer detent balls (9) from pop­
ping out.
A. Scribe on hub and sleeve so the parts can be
reinstalled in the same position.
B. Leave the synchronizer ring (2) on the fifth-re­
verse synchronizer assembly (26) to prevent
the synchronizer detent balls (9) from popping
out.
3707r5193