GMC T Series 1994 Repair Manual page 675

Figure 114 Outside Electrical Connector
E3
Install or Connect
Figure 115
1. Filter seal (71) onto the oil filter.
• Lubricate w ith Transjel™ J 36850 or
equivalent.
2. Oil filter (72).
3. Oil pan gasket (73).
4. Chip magnet (74) onto oil pan (75).
5. Oil pan (75) and bolts (76).
[$Q Tighten
• Torque to 12 N»m (9 lb. ft.)
Figure 115 Case, Pan and Filter Assembly
2-4 Servo Assembly
Figures 116 through 120
Tools Required:
J 33037 Band Apply Pin Tool
Vernier calipers
Scale
J 22269-01 Piston Compressor
J 29714 Servo Cover Compressor
Iffi] Measure
Figure 116
1. Install J 33037 as shown with apply pin (13).
2. Install servo cover retaining ring (29) to secure
tool.
3. Apply 11 N«m (98 lb. in.) torque.
4. If white line "A" appears in the gage slot "B",
pin length is correct.
5. Use pin selection chart to determine the correct
pin length if new pin is needed.