200. HOUSING, FRONT
203. BEARING, COUNTERSHAFT
218. BEARING, INPUT SHAFT
310. SUPPORT, IDLER SHAFT
311. BOLT, 22 N-m (16 LBS. FT.)
312. BOLT, 35 N-m (26 LBS. FT.)
321. PIN, DOWEL
Figure 11—Removing and Installing Special Tools
21. Shift shaft (108), shift shaft socket assembly (114),
22. Rotate third-fourth shift fork (102) counterclockwise
23. Loosen, but do not remove, 3 bolts (304) on the
3707r5188
24. Install J 36515-15 and J 36515-16 onto the input
25. J 8763-02 and J 36824 from the housing.
26. Bolts (304) from the rear housing (2WD only) (fig
J 36515
• Drive shift socket pin down using a 5-mm
(3/16-inch) punch.
• Pin will fall into the case.
N O T IC E : E x c e s s iv e f o r c e w ill "p e e n " t h e s h i f t
s h a f t a n d d a m a g e t h e r e a r h o u s in g s h i f t s h a f t
b e a r in g (3 0 9 ) c a u s in g i n c r e a s e d s h i f t e ffo r t.
anti-rotation bracket (112), biasing spring (109),
lever (104), and shift shaft block out bushing (103).
and remove.
rear of case (2WD only).
and countershaft. Install J 36515 to the transmis
sion assembly (figure 11).
ure 12).
J 3289-20
3707r5174