17. Rear Case Half
18. Oil Pump Pick Up Tube
26. Connector
19. Rear extension housing (4) and extension housing
bolts (3) to the pump retainer housing (8).
•A p p ly RTV sealer (GM P/N 1052366) to the
extension housing mating surfaces.
• Apply Loctite 242 or (GM P/N 12345382) to the
extension housing bolts.
Tighten
$
• Bolts to 31 N-m (23 lbs. ft.).
EXTERNAL COMPONENTS
■*«-
Install or Connect (Figures 3 and 4)
N O T IC E : F o r s t e p s 1 th r o u g h 4 , r e f e r to " N o
t i c e " o n p a g e 7 D 3 -1 .
1. Selection plunger (70), poppet spring (71), O-ring
seal (69), and poppet screw (68) into front case
half (45).
33. Dowel Pin Location
35. Pump Pick Up Screen
Figure 15— Oil Pump Location
2. Speedometer sensor and O-ring to the pump hous
3. Vacuum switch (46) and O-ring (47) to the front
4. Front output yoke (74), rubber sealing washer (75),
Tighten
$
• Poppet screw to 15 N-m (11 lbs. ft.).
ing (8).
• Sensor to 31 N-m (23 lbs. ft.).
case housing.
Tighten
$
• Switch to 24 N-m (17 lbs. ft.).
washer (76), and yoke nut (77).
Tighten
• Front output yoke nut (77) to 149 N-m (110 lbs.
ft.).
F5434