GMC T Series 1994 Repair Manual page 640

IF GAGE DIMENSION "D" IS
FROM
28.065m m
(1.102")
28.586m m
(1.122")
27.544m m
(1.081")
B
Install or Connect
Figures 38 and 40
1. Waved plate (682A).
2. Correct selective spacer plate (682B), from
selection procedure.
3. Lo and reverse clutch plates (682) into case
lugs.
• Start with a composition plate and alternate
with steel.
• Index with the splines of the reaction carrier
and the case as shown.
Figure 40 Lo and Reverse Clutch Plates Properly
Installed
LO AND REVERSE CLUTCH SPACER PLATE SELECTION CHART
IDENTIFICATION
TO
27.545m m
(1.081")
28.066m m
(1.102")
27.026m m
(1.061")
Figure 39 Lo and Reverse Spacer Plate Selection Chart
USE THIS SELECTIVE PLATE
1.684mm
NONE
(.066")
1.314m m
0
(.052")
2.198m m
1
(.087")
8 CASE, TR A N SM ISSIO N
681 CARRIER ASSEMBLY, REACTION
682 PLATE ASSEMBLY, LO A N D REVERSE CLUTCH
682A PLATE, LO A N D REVERSE CLUTCH (WAVED)
682B PLATE, SPACER LO A ND REVERSE CLUTCH
(SELECTIVE)
683 BEARING ASSEMBLY, THRUST (REACTION CARRIER/
SUPPORT)
684 GEAR, INTERNAL REACTION
685 SUPPORT, INTERNAL REACTION GEAR
692 BRG., REACTION GEAR SUPPORT TO CASE
697 DEFLECTOR, OIL (HIGH O UTPUT
M ODELS ONLY)
PLATE THICKNESS
1.829m m
(.072")
1.168m m
(.046")
2.344m m
(.092")
RH0136-4L60-E
RH0138-4L60-E