55
PIN, FRONT SERVO PISTON
56
RING, FRONT SERVO SPRING RETAINER
57
RING, OIL SEAL
58
PISTON, FRONT SERVO
60
SPRING, FRONT SERVO PISTON
Figure 104 Front Servo Assem bly
BAND APPLY PIN CHECK
Figures 105,106 and 107
Tools Required:
J 21370-10 Gage Pin
J 38737 Band Apply Pin Checking Tool
| ^ |
Measure
1. Place J 21370-10 in the servo pin bore.
2. Position J 38737 over the bore with the hex nut
facing the parking pawl linkage.
3. Fasten with two servo cover bolts (61).
Tighten
•
Bolts (61) to 24 N*m (18 lb. ft.).
4. Make sure J 21370-10 moves freely in the tool
and pin bore.
5. To determine correct pin length apply 25 lb. ft.
torque to the nut on the gage.
6. For pin selection, see Figure 107.