3. Index J 8001 against end of turbine shaft.
•
Set dial to "0".
4. Pull out turbine shaft (502) while holding output
carrier up.
•
Increase lifting force to approximately 20
lbs.
•
Proper end play is 0.102 to 0.559 mm (0.004
to 0.022 inch).
5. Remove tools and correct end play if necessary.
6. Install O-ring (2) on turbine shaft.
7. Install seal assembly (201) using J 38694, if
necessary.
THICKNESS (INCH)
.057 - .061
.073 - .077
.089 - .093
.105- .109
.121 - .125
Figure 103 Selective Washer (218)
FRONT SERVO ASSEMBLY
F ig u re 104
E
Install or Connect
•
Front servo assembly into case.
-
Make certain tapered end of piston pin (55)
contacts band.
STRIPE
BLUE
RED
BROWN
GREEN
PLAIN
RH0113-4L80-E