GMC T Series 1994 Repair Manual page 856

3. Bearing (61) into front case half (45) using J 37371
(figures 11 and 12).
4. Bearing retainer (60) into front case half (45).
5. Bearing (6) into pump retainer housing (8) using
J 36371 (figures 13 and 14).
6. Bearing (84) to the input gear (38) using J 36372
and J 8092.
7. Thrust washer (37).
8. Carrier lock ring (78).
9. Retainer (87).
10. Bearing (40) to the input gear (38) using J 36373.
Front Drive Sprocket
45. Front Case Half
Figure 12— Installing the Front Output Bearing with
J 36371
11. Retainer ring (snap ring) (41) to the input gear (38).
12. Oil seal (1) to rear extension (4).
13. Input bearing retainer seal (42) to the input bearing
retainer (44).
14. Front output shaft seal (72) to the front case half
(45).
15. Magnet (25) to front case half (45).
INTERNAL COMPONENTS
❖ Assemble (Figures 15 through 19)
1. Spring retainers (32) to the synchronizer hub (31).
2. Synchronizer hub (31) to the synchronizer sleeve
(29) along with the three struts (30).
• Align the previously scribed marks.
3. Main drive synchronizer stop ring (28) to the syn­
chronizer sleeve (29).
-► 4-
Install or Connect
N O T IC E : F o r s t e p s 6, 8 , 2 2 , a n d 2 6 , r e f e r to
"N o t i c e " o n p a g e 7 D 2 -1 .
1. Drive sprocket (20) to the mainshaft (19).
2. Synchronizer assembly (81) to the mainshaft (19).
3. Synchronizer retainer snap ring (83) to the main­
shaft (19).
4. Input gear (38) and planetary assembly (36) into
the annulus gear (62) using a soft faced hammer.
5. Bearing retainer (snap ring) (39) to the input bear­
ing (40).
6. Input bearing retainer (44) and input bearing retain­
er bolts (43) to the front case half (45).
• Apply RTV (GM P/N 1052366) to bearing retain­
er mating surfaces.
•A p p ly Loctite 242 or (GM P/N 12345382) on
bearing retainer bolts.