GMC T Series 1994 Repair Manual page 798

assembly bore MUST be heated for 3 to 5 min­
utes with J 25070 before assembly (figure 48).
10. J 36515-10 through bolt (304) and (305) holes in
the rear housing (figure 49) (2WD models only).
• Screw into the output shaft bearing retainer
(302).
• Notch in retainer towards oil delivery tube
assembly (307).
11. Bearing (203). (2WD models only.)
A. Install in bearing race (202) of the housing, with
the smaller diameter of the bearing cage into
the bearing race.
B. Retain with TRANSJEL ™ J 36850 or equiva­
lent.
Important
• Press each roller towards the race to secure
them for easier assembly.
12. Rear housing assembly (300) (2WD models only).
A. Make sure the reverse idler shaft is lined up
with the hole in the case.
B. Rotate back and fourth while pulling down.
C. Pull up on J 36515-10 while installing rear
housing.
Important
• Bring the housing straight down. If resistance is
felt at about 7 mm (1/4 in.), then the rollers
(203) are cocked. Repeat above procedures to
install. Do not force housing down.
13. Bolts (304) (figure 50) (2WD models only).
A. Apply pipe sealant with Teflon ™ GM P/N
1050280 or equivalent to the bolt holes of the
rear housing.
B. Apply threadlocker GM P/N 12345382 to bolt
threads.
C. Remove J 36515-10.
Tighten
&
• Bolts (304) to 22 N-m (16 lbs. ft.).
14. Bearing (203) (figure 13) (4WD models only).
A. Install in bearing race (202) of the housing.
J 36515-10
302
NOTE:
NO TCH IN
RETAINER
TOW ARDS
BACKUP LAMP
SW ITCH HOLE
J 36515
203. BEARING, C O U N TER SH A FT
300. H O U SIN G , REAR (2W D)
302. RETAINER, O UTPUT SHAFT BEARING (2W D)
NOTE: SMALL
DIAMETER OF
BEARING
CAGE INTO
RACE
J36515-12
P
^
■
3707r5191