GMC T Series 1994 Repair Manual page 755

33 CLAMP, ELECTRICAL CABLE
34 HARNESS ASSEMBLY, ELECTRICAL WIRING
35 BOLT, HEX HD. - M6 X 1.0 X 55.0
36 BOLT, M 6 X 1.0X 35.0 LG V.B. TO C.P.
37 RETAINER, LUBE PIPE
38 CLAMP, LUBE PIPE
39 PIPE, LUBE
40 SWITCH ASM., A/TRANS. FLUID PRESS.
41 SPRING ASSEMBLY, MANUAL DETENT
43 STOP, FLUID LEVEL INDICATOR (DIPSTICK)
44 BODY ASSEMBLY, CONTROL VALVE
51 HOUSING, ACCUMULATOR
75 SCREEN, PWM SOLENOID
76 BOLT, SPECIAL
PAN AND FILTER ASSEMBLY
Figure 112
EB
Install or Connect
1. Seal (32) inside of case (7).
2. Filter assembly (31).
3. Bottom pan seal (29).
4. Magnet (30) into bottom pan.
5. Pan (29).
6. Seventeen bolts (27) using 10 mm socket.
|j& l
CASE EXTENSION ASSEMBLY
Figure 113
Tool Required:
Q j Install or Connect
1. O-ring and orifice assembly (12) to rear of case.
2. Seal (13) and snap ring (14) into rear of case.
3. O-ring (15) onto extension assembly.
4. Extension Assembly (19).
5. Six bolts (21) using 15 mm socket.
| ^ |
6. New rear seal (20) with J 38694 or J 38869.
RH0103-4L80-E
Tighten
• Bolts (27) to 24 N*m (18 lb. ft.)
J 38693 Rear Lube Seal Installer/Case
J 38869 Case Extension Seal Installer
Tighten
• Bolts (21) to 34 N*m (25 lb. ft.).
• Apply TRANSJEL™ J 36850 or equivalent
to spring pocket.