GMC T Series 1994 Repair Manual page 576

SUBJECT
Drive E n d .............................. .....................................................................................................................................6D2A-12
Frame and Field A ssem b ly.................................................................................................................................. 6D2A-13
Pinion Clearance C h e c k ....................................................................................................................................... 6D2A-13
S p ecifications............................................................................................................................................................... 6D2A-14
Starter.......................................................................................................................................................................... 6D2A-14
Solenoid S w itches...................................................................................................................................................6D2A-14
Fastener Tightening Specifications....................................................................................................................6D2A-14
Lubrication................................................................................................................................................................. 6D2A-14
DELCO REMY SD
STARTER MOTORS
The straight-drive type starter motors covered in this
section have enclosed shift levers (figure 1).
The starter motor has the drive end housing extended
to enclose the shift lever and solenoid plunger. The
solenoid flange mounts to the extension of the drive
end housing with sealing compound between the flange
and the field frame.
The starter motor bearings are lubricated during
motor assembly and do not require service except dur­
ing motor repair.
9
1. Shift Lever
2. Plunger
3. Solenoid
4. Bushing
5. Return Spring
CONTENTS (cont'd)
GENERAL DESCRIPTION
2 5
8
6. Pinion Stop
8. Field Coil
9. Armature
32. Drive Assembly
F4207
IDENTIFICATION
The part number can be found either stamped on the
outside of the frame or on an identification tag attached
by a through bolt.
PAGE