GMC T Series 1994 Repair Manual page 560

FLYWHEEL INSTALLATION
4
-► - Install or Connect (Figure 90)
1. Flywheel (19).
N O T IC E : R e f e r to " N o t i c e " o n p a g e 6 A 7 -1 .
2. Bolts (18).
Tighten
• Bolts (18) to 90 N-m (65 lbs. ft.).
ENG INE SETUP AND TESTING
1. After overhaul, the engine should be tested before
installation in the vehicle. If a suitable test stand is
not available, the following procedure can be used
after the engine is installed in the vehicle.
2. Fill the crankcase with the proper quantity and
grade of oil and install a new oil filter. Refer to
SECTION OB. Replacement of the engine oil and
filter is recommended, especially if a new camshaft
was installed.
3. Fill the cooling system with the proper coolant.
4. With the shutdown solenoid disconnected, crank
the engine several times. Listen for any unusual
noises or evidence that any parts are binding.
5. Start the engine and listen for unusual noises. Run
the engine at about 1000 rpm until the engine is at
operating temperature.
Figure 90— Flywheel Installation
Listen for sticking lifters, and other unusual
noises. Check for oil and coolant leaks while the
engine is running.
Using the Emission Control Label for specifica­
tions, adjust idle speed, fast idle speed, etc. as
required.