GMC T Series 1994 Repair Manual page 757

SPEED SENSOR ASSEMBLIES
Figure 114
E3
Install or Connect
1. Two speed sensor and bracket assemblies (22)
onto case.
2. Two bolts (23) using 8 mm socket.
3. Case oil test plug (24) (if removed).
Tighten
• Bolts (23) and (24) to 11 N*m (97 lb. in.).
12 CUP, ORIFICE W/SEAL/PLUG-REAR LUBE (4WD)
13 SEAL ASSEMBLY, REAR LUBE
14 RING, SNAP SEAL RETAINER
15 SEAL, EXTENSION TO CASE
19 EXTENSION ASSEMBLY, CASE
20 HELIX SEAL ASSEMBLY, CASE EXTENSION
21 BOLT, HEX HD - M 1 0 X 1 .5 X 3 0 .0
675 SEAL, O-RING OUTPUT SHAFT
Figure 113 Installing Case Extension Assem bly
22 SENSOR ASM, A/TRANS. INPUT SPD. AND VEH. SPD. -
23 BOLT, METRIC HEX
86 PLUG, SENSOR BORE (SOME MODELS)
Figure 114 Installing Speed Sensor Assemblies
TORQUE CONVERTER ASSEMBLY
Tool Required:
J 21366 Converter Holding Strap
p + | Install or Connect
• Torque converter (1) with J 21366.
NOTICE:
Transmission must be in the vertical
position.
- Engage turbine shaft, stator shaft and lugs
on pump driven gear until converter is fully
engaged.
RH0109-4L80-E
RHQ L £