GMC T Series 1994 Repair Manual page 242

J 36613 Bearing Installer (K3 Models)
J 8092 Driver Handle
J 36599 Sleeve Adjusting Wrench
J 36615 Adjuster Plug Wrench (K3 Models)
J 36603 Side Bearing Cup Installer
1. Bearings (30) to the sleeves (32) and/or adjuster
plug (61) (K3 models).
•U s e J 8092 and J 36612 (K1, 2 models) or
J 36613 (K3 models) (figure 27).
2. New O-ring seal (62) to the adjuster plug (61) (K3
models).
3. Sleeves (32) and/or adjuster plug (61) to the carrier
case (29).
• K1, 2 models: Use J 36599 (figure 28).
• K3 models: Use J 36599 for the right sleeve
(figure 28). Use J 36615 for the adjuster plug
(figure 29).
4. Side bearing cups (33). Use J 36603 with J 8092
(figure 30).
5. Differential assembly to the carrier case half.
• Place the differential assembly into the carrier
case half which contains the pinion gear.
•T u rn the left sleeve (32) (K1, 2 models) or
adjuster plug (61) (K3 models) in until backlash
is felt between the ring and pinion.
• K1, 2 models: Use J 36599 (figure 28).
• K3 models: Use J 36615 (figure 29).
• Remove the carrier case from J 36599.
p i
W
Figure 27— Installing the Adjuster Sleeve Bearing
J 8092
J 36612 (K15-25)
J 36613 (K35)
F5872
F5857
61. A djuster
63. Bolt
64. Lock
Figure 29—Turning the Adjuster Plug (K3 Models)
Figure 30— Installing the Side Bearing Cups
6. Carrier case halves. Do not use sealer at this time.
• If the carrier halves do not make complete con­
tact, back out the right sleeve (32). Use
J 36599 (figure 28).
NOTICE: Refer to "Notice" on page 4C2-1.
7. Bolts (28).
Tighten
F5858