GMC T Series 1994 Repair Manual page 749

26 BOLT, CASE (4TH CLUTCH)
529 HOUSING, 4TH CLUTCH
Figure 95 Installing 4th Clutch Bolt
TURBINE SHAFT AND OVERDRIVE CARRIER
ASSEMBLY
E Install or Connect
Figure 96
1. Complete assembly into case.
| 9 | Important
• Be sure assembly is fully engaged and is at
the level of the 4th clutch nousing. Using
selective thrust washer (218) onto top of
overrun housing and straight edge to pump
to cage surface. The two surfaces should be
flush.
FOURTH CLUTCH PLATES
|hhh| Install or Connect
Figures 97 and 98
1. Fourth clutch plates (525 and 526) starting with
steel first into 4th clutch housing around
overdrive carrier assembly.
NOTE:
("V" notch) at the 1 o'clock position in the housing.
2. Backing plate (524) with wide surface against
the composition plate (525).
3. Fourth clutch snap ring (523) into the fourth
clutch housing (529).
RH0183-4L80-E
Install steel plates with the narrow tang