Terminal Block -X9 - Siemens Sinamics G120P Operating Instructions Manual

X126: CAN Bus connection
Table 4- 33 CAN Bus connection X12
Pin Designation
1 --
2 CAN_L
3 CAN_GND
4 --
5 (CAN_SHLD)
6 (GND)
7 CAN_H
8 --
9 --
Connector type: 9-pin SUB-D male
4.8.2

Terminal block -X9

Note
Pre-assignment of the X9 terminal block
Depending on the cabinet type and option selection, the X9 terminal block can already be
pre-assigned from the factory.
The factory setting and description of the X9 terminal block can be found in the circuit
diagrams.
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
Technical data
not used
CAN signal (dominant low)
CAN ground
not used
Optional shield
Optional ground
CAN signal (dominant high)
not used
not used
Electrical installation
4.8 Signal connections
99