Siemens Sinamics G120P Operating Instructions Manual page 160

Commissioning
5.5 Procedure for commissioning via STARTER
Default settings for setpoints/command sources
Figure 5-21
⇒ Select the preselection of the setpoints and command sources; the list of selection options
depends on the deployed Control Unit, see also Section Pre-assignment of inputs/outputs
and wiring via p0015 macros (Page 124):
● No selection
● 7.) Fieldbus with data set switchover
● 9.) Standard I/O with MOP
● 12.) Standard I/O with analog setpoint
● 14.) Process industry with fieldbus
● 15.) Process industry
● 17.) 2-wire (forw/backw1)
● 18.) 2-wire (forw/backw2)
● 19.) 3-wire (enable/forw/backw)
● 20.) 3-wire (enable/on/reverse)
● 21.) USS fieldbus
● 22.) CAN fieldbus
⇒ Click on Continue >
160
Default settings for setpoints/command sources
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A