Siemens Sinamics G120P Operating Instructions Manual page 149

Figure 5-8
⇒ Select the access point:
● Select the S7ONLINE access (STEP7), if the connection to the drive unit is established
via PROFINET or PROFIBUS.
● Select the DEVICE access, if the connection to the drive unit is established via the USB
interface.
⇒ Click on OK, to acknowledge the selection and close the window.
⇒ In the previous window, click on PG/PC ... and set up the interface in accordance with your
device configuration.
The Properties..., Copy..., Delete... and Select... buttons are now active.
Figure 5-9
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
Setting the access point
Setting the interface
5.5 Procedure for commissioning via STARTER
Commissioning
149