Commissioning The Drive Unit - Siemens Sinamics G120P Operating Instructions Manual

Commissioning
5.5 Procedure for commissioning via STARTER
5.5.3

Commissioning the drive unit

Selecting options
Figure 5-19
⇒ From the combination box Options selection: select the options belonging to your drive
unit by clicking on the corresponding checkbox (see type plate).
Note
Motor reactor or dv/dt filter
During option selection it is essential to activate any motor reactor (option L08) or dv/dt filter
(option L07, L10) being used, otherwise the motor control will not perform at its best.
Note
Check option selection
Check your options carefully against the options specified on the type plate.
⇒ Check your options carefully and then click Continue >
158
Selecting options
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A