Siemens Sinamics G120P Operating Instructions Manual page 265

SDO abort codes
Abort code
0503 0000 hex
0504 0000 hex
0504 0001 hex
0504 0002 hex
0504 0003 hex
0504 0004 hex
0504 0005 hex
0601 0000 hex
0601 0001 hex
0601 0002 hex
0602 0000 hex
0604 0041 hex
0604 0042 hex
0604 0043 hex
0604 0047 hex
0606 0000 hex
0607 0010 hex
0607 0012 hex
0607 0013 hex
0609 0011 hex
0609 0030 hex
0609 0031 hex
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
Description
Toggle bit not alternated.
SDO protocol timed out.
Client/server command specifier not valid or unknown.
Invalid block size (block mode only).
Invalid sequence number (block mode only).
CRC error (block mode only).
Out of memory.
Unsupported access to an object.
Attempt to read a write only object.
Attempt to write a read only object.
Object does not exist in the object dictionary.
Object cannot be mapped to the PDO.
The number and length of the objects to be mapped would exceed PDO length.
General parameter incompatibility reason.
General internal incompatibility in the device.
Access failed due to an hardware error.
Data type does not match, length of service parameter does not match.
Data type does not match, length of service parameter too high.
Data type does not match, length of service parameter too low.
Subindex does not exist.
Value range of parameter exceeded (only for write access).
Value of parameter written too high.
6.9 Communication over CANopen
Operation
265