Siemens Sinamics G120P Operating Instructions Manual page 177

Example 1: interconnecting digital signals
Suppose you want to operate a drive via terminals DI 0 and DI 1 on the Control Unit using
jog 1 and jog 2.
Figure 6-4
Binector-connector converters and connector-binector converters
Binector-connector converter
● Several digital signals are converted to a 32-bit integer double word or to a 16-bit integer
word.
● p2080[0...15] BI: Binector-connector converter, status word 1
● p2081[0...15] BI: Binector-connector converter, status word 2
● p2082[0...15] BI: Binector-connector converter, status word 3
● p2083[0...15] BI: Binector-connector converter, status word 4
● p2084[0...15] BI: Binector-connector converter, status word 5
Connector-binector converter
● A 32-bit integer double word or a 16-bit integer word is converted to individual digital
signals.
● p2099[0...1] CI: Connector-binector converter signal source
Fixed values for interconnection using BICO technology
The following connector outputs are available for interconnecting any fixed value settings:
• p2900[0...n]
• p2901[0...n]
• p2930[0...n]
Example:
These parameters can be used to interconnect the scaling factor for the main setpoint or to
interconnect an additional torque.
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
Interconnection of digital signals (example)
CO: Fixed value 1[%]
CO: Fixed value 2[%]
CO: Fixed value M [Nm]
6.2 Basic information about the drive system
Operation
177