Rear Brake Pads; Pad Removal; Brake Pad Inspection - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

BRAKE SYSTEM

REAR BRAKE PADS

PAD REMOVAL

1. Elevate and support rear of machine.
WARNING
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur if machine tips or falls.
2. Remove the rear wheel. Loosen pad adjuster screw
q
2-3 turns.
3. Clean caliper area before removal.
4. Remove caliper mounting bolts
of disc.
CAUTION
When removing caliper, be careful not to damage brake
line. Support caliper so as not to kink or bend brake
9.18
w
and lift caliper off
line.
5. Push caliper piston into caliper bore slowly with pads
installed.
NOTICE
Brake fluid will be forced through compensating port
into master cylinder fluid reservoir when piston is
pushed back into caliper. Remove excess fluid from
reservoir as required.
6. Remove the brake pads.

BRAKE PAD INSPECTION

1. Check the brake pads for wear, damage, or
looseness.
2. Inspect the brake pad wear surface for excessive
wear.
MEASUREMENT
Brake Pad
.030" (0.762 mm)
3. If any one pad is less than the service limit then all
pads should be replaced.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN