Shift Cable; Inspection; Adjustment - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

TRANSMISSION

SHIFT CABLE

INSPECTION

Shift cable adjustment may be necessary if symptoms
include:
• No gear position display on instrument cluster
• Inability to engage into or stay in a gear
• Excessive gear lash (noise)
Inspect shift cable, clevis pins, and pivot bushings and
replace if worn or damaged.
6.8

ADJUSTMENT

1. Locate the shift cable attached to the transmission
case in the right rear wheel well area.
2. Inspect shift cable, clevis pin, pivot bushings, and
dust boot. Replace if worn or damaged.
3. If adjustment is required, loosen the lower jam nut
and pull the cable out of the mount to move the
w
upper jam nut .
4. Adjust the shift cable so there is the same amount of
cable travel when shifting slightly past HIGH gear
and PARK.
5. Thread the upper or lower jam nut as required to
obtain proper cable adjustment.
NOTICE
This procedure may require a few attempts to obtain
the proper adjustment.
6. Once the proper adjustment is obtained, place the
shift cable and upper jam nut into the mount. Tighten
the lower jam nut against the mount.
7. Start engine and shift through all gears to ensure the
shift cable is properly adjusted. If transmission still
ratchets after cable adjustment, the transmission will
require service.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
q
© Copyright TAYLOR-DUNN