Starter One-Way Clutch Installation; Flywheel Installation - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

9. Inspect drive surface of starter gear
u
surface for wear, damage, or uneven surface. If any
starter clutch component is worn or damaged,
replace clutch, clutch hub, and starter gear.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
y STARTER ONE-WAY CLUTCH
and bearing
INSTALLATION
1. Install one-way clutch in clutch hub with flange of
clutch
The one-way clutch can be installed into the hub
incorrectly. This will cause engine cranking issues.
2. Clean screw threads in flywheel to remove all oil or
grease.
3. Apply Loctite® 272™ on the three bolts. Place hub on
flywheel and install bolts.
4. Torque screws to specification.
9 ft-lbs (12 Nm)Apply Loctite® 272™

FLYWHEEL INSTALLATION

1. Clean the threads, taper and flat of crankshaft to
remove all oil or grease.
ENGINE / COOLING SYSTEM
i
engaged in recess.
NOTICE
TORQUE
One Way Clutch Retaining Bolts:
3
3.73