Roller, Pin, And Thrust Washer Inspection; Button To Tower Clearance Inspection - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

ROLLER, PIN, AND THRUST WASHER
INSPECTION
1. Inspect all rollers, bushings and roller pins by pulling
a flat metal rod across the roller. Turn roller with your
finger. If you notice resistance, galling, or flat spots,
replace rollers, pins and thrust washers in sets of
three. Also inspect to see if roller and bushing are
separating. Bushing must fit tightly in roller. Use the
Roller Pin Tool to replace rollers and pins. Take care
not to damage roller bushing or bearing surface of the
new pin during installation.
Roller Pin Tool:
PN 2870910
2. Rubber backed buttons can be used in TAYLOR-
DUNN clutches if the hollow roller pin is changed to
the solid roller pin.
NOTE
The rubber side of the button is positioned toward the
solid roller pin.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
BUTTON TO TOWER CLEARANCE
INSPECTION
1. Inspect for any clearance between spider button to
tower. If clearance exists, replace all buttons and
inspect surface of towers. See "Spider Removal"
procedure.
Button to Tower Clearance:
.000-.010"
2. Inspect sheave surfaces. Replace the entire clutch if
worn, damaged or cracked.
CVT SYSTEM
5
5.17